Patton electronic 29XX User Manual download pdf (Page 324)

Configuring a leased line/dedicated line connection 324

Access Server Administrators’ Reference Guide C • Technical Reference

2. If you wish to apply the parameters specified in steps 1 and 2 based on WAN port then enter the appropri-

ate WAN port. Enter 0 if you want to apply the parameters based on number dialed only.

3. Enter the number dialed—this is not optional. Multiple phone numbers can be entered separated by semi-

colons (;).

Note

The number dialed in the phone number received by the RAS from the

switch. Check the

Telco

link on the

Dial-in

main window to verify the phone

numbers sent by the switch.

Configuring a leased line/dedicated line connection

The remote access server can connect to a remote modem for dedicated modem access.

Configuring the RAS

1. Configure the Line Interface Settings as usual for the T1/E1.

2. Configure the

Signalling Settings

using

none(1)

for

Signal Mode

. No other settings are necessary.

Figure 134. Signalling Settings window

3. Configure Channel Assignment for the T1/E1 setting each timeslot for which you want a dedicated con-

nection to

leasedLine(4)

Figure 135. WAN Circuit Channel Assignment window

4. Set Maximum V8 failures under Dialin->Modify Defaults in the Modem Configuration section. This will

configure the number of times the modem on the remote access server will attempt to dial out before stop

1 2 ... 319 320 321 322 323 324 325 326

No comments

Patton electronic 29XX User Manual Page 324