Patton electronic 29XX User Manual download pdf (Page 18)

Immediate Actions 18

Access Server Administrators’ Reference Guide 2 • Home

Immediate Actions

There are several immediate actions (see figure 5) which, when in superuser mode, will cause the access server

to operate according to the descriptions in the following sections.

Figure 5. Immediate Actions buttons

•

Record Current Configuration

—clicking this button causes the current configuration to be stored in

FLASH memory. Any changes made to the access server configuration are stored in non-volatile RAM. This

allows the user to set the box up with a running configuration before committing it to FLASH. Configura

tion changes become permanent when you select

Record Current Configuration

. You will lose all changes

not stored to FLASH the next time the access server is re-booted.

•

Hard Reset

—this button causes the access server to perform a cold restart. When you select

Hard Reset

, the

access server confirm that you want to execute this command. Then, the access server will disconnect all

current sessions, re-initialize the interfaces, and re-load configuration parameters from FLASH.

•

Set Factory Default Configuration

—this button clears out the configuration in FLASH and loads the fac-

tory default parameters into FLASH memory. The factory default settings will not execute on the access

server until it is re-booted.

Note Set Factory Default Configuration

will delete any routing information, the

access server’s Ethernet IP address, and any other site specific settings made

for your particular installation. You will have to re-enter the access server’s

Ethernet IP address and netmask using the front panel control port in order

to use the HTTP/HTML Management pages.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 325 326

No comments

Patton electronic 29XX User Manual Page 18