Patton electronic 29XX User Manual download pdf (Page 205)

IP Routing Destination window 205

Access Server Administrators’ Reference Guide 16 • IP

Info (ipRouteInfo)

A reference to MIB definitions specific to the particular routing protocol which is responsible for this route, as

determined by the value specified in the route’s ipRouteProto value. If this information is not present, its value

should be set to the OBJECT IDENTIFIER { 0 0 }, which is a syntactically valid object identifier, and any

conformant implementation of ASN.1 and BER must be able to generate and recognize this value.

IP Routing Destination window

The

IP Routing Destination

window (see figure 86) shows next-hop routing information. Clicking on a Desti-

nation in the IP

Routing Information

window displays this window.

Figure 86. Routing Destination window

Route Destination (ipRouteDest)

The destination IP address of this route. An entry with a value of 0.0.0.0 is considered a default route. Multiple

routes to a single destination can appear in the table, but access to such multiple entries is dependent on the

table-access mechanisms defined by the network management protocol in use.

Mask (ipRouteMask)

Indicates the mask to be logical-ANDed with the destination address before being compared to the value in the

ipRouteDest field. For those systems that do not support arbitrary subnet masks, an agent constructs the value

of the ipRouteMask by determining whether the value of the corresponding ipRouteDest field belongs to a

Class A, B, or C network, and then using the appropriate mask from

Table 3 on page 200.

Interface (ipRouteIfIndex)

The index value which uniquely identifies the local interface through which the next hop of this route should

be reached. The interface identified by a particular value of this index is the same interface as identified by the

same value of ifIndex.

Protocol (ipRouteProto)

The routing mechanism via which this route was learned. Inclusion of values for gateway routing protocols is

not intended to imply that hosts must support those protocols.

• unknown(0)

• local(1)—Added by the access server to support an interface. For example, adding a route for a new dial-in

user.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 325 326

No comments

Patton electronic 29XX User Manual Page 205