Patton electronic 29XX User Manual download pdf (Page 323)

Configuring DNIS 323

Access Server Administrators’ Reference Guide C • Technical Reference

Configuring DNIS

DNIS (Dialed Number Identification Service) is a telephone service that identifies for the the receiver of the

call the number that the caller dialed. DNIS works by passing the touch-tone digits (dual-tone multi-frequency

of MF digits) to the destination where a special facility can read and display them or make them available for

use by the terminating device.

The RAS uses its ability to capture DNIS information to provide the customer the ability to set up parameters for

their dial-in clients based on the phone number that has been dialed or which physical WAN port they have dialed

into. If none of the specified conditions are met then the default conditions of the RAS will be applied to the user.

In its current implementation the following parameters can be configured based on DNIS:

• Authentication: can select traditional authentication or no validation

• IP Address Pool

• Data over voice bearer services

Setting up IP address pools by configuring DNIS Ip Pools

Note

This section is optional. If you are not going to set up IP address pools, refer

to section

“Setting up a DNIS user profile”.

If IP address pools are to be assigned based on DNIS or WAN port, configure your DNIS Ip Pools (see

figure 35 on page 86) as follows:

1. Enter an ID number to identify the IP address pool

2. Enter the IP address range.

3. Click on the

Submit Query

button.

Setting up a DNIS user profile

Set up a DNIS user profile (see figure 33 on page 81) to be applied based on DNIS or WAN port as follows:

1. Enter an ID number to identify the specific DNIS profile.

2. Enter the ID for the IP address pool if you wish to apply a specific set of IP addresses to these users. Use 0

if you wish the users to use the default IP address pool or a static IP address from RADIUS.

3. Set the authentication type.

4. Enable data over voice bearer services if desired. This allows either 64k or 56k ISDN calls.

5. If you wish to redirect the users to a remote host or service on a remote host then enter the remote host’s IP

address and port the application is listening at. For example, telnet listens on port 23.

6. Click on the

Submit Query

button.

Setting up a DNIS group

Set up a DNIS group (see figure 31 on page 77) as follows:

1. Enter an ID number to identify the specific DNIS profile.

1 2 ... 318 319 320 321 322 323 324 325 326

No comments

Patton electronic 29XX User Manual Page 323