Patton electronic 29XX User Manual download pdf (Page 262)

WAN Circuit Configuration—Modify 262

Access Server Administrators’ Reference Guide 22 • T1/E1 Link

Robbed-Bit Signalling Protocol (linkSignalling)

This variable determines which robbed bit signalling technique is used. The techniques designated OFFICE

are used to simulate the central office site. These allow back to back connection of access servers. This is set

only when the signal mode is robbedBit(2)

• linkGroundStart(1)

• linkLoopStart(2)

• linkOfficeGroundStart(3)

• linkOfficeLoopStart(4)

• linkEMWinkStart(6)

• linkEMImmediateStart(7)

• linkTaiwanR1(8)

Message-Oriented Switch Type (linkIsdnSwitchType)

This object allows the selection of the ISDN variations on the ISDN protocol, depending on the brand of

switch to which the access server is connected. This only needs to be set when messageOriented is chosen for

signalling protocol.

• ni1(0)—National ISDN-1

• dms(1)—Northern Telecom

• att(2)—AT&T Lucent

• ctr4(3)—E1 ISDN

• ts014(4)—Australia AUSTEL

• ins1500(5)—Japan

• nfasSlave(7)—T1 that uses the D channel of another T1 for signalling

NFAS Interface ID (linkNfasInterfaceId)

The ID number assigned to the PRI by the telephone company. The interface ID is used by the common D

channel to determine which PRI in the NFAS group will receive the incoming call.

NFAS Primary WAN (linkNfasPrimaryPointer)

The WAN port that the PRI with the common D channel is plugged into.

Test Settings

This portion of the WAN Circuit Configuration window contains information described in the following

sections.

Force Yellow Alarm (linkYellowForce)

This variable identifies which standard will be used to transmit and identify the Yellow Alarm.

• linkYellowAuto—Do not force the transmission of a yellow alarm. But, yellow alarm may be automatically

transmitted.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 325 326

No comments

Patton electronic 29XX User Manual Page 262