Patton electronic Model 3088/I User Manual download pdf (Page 52)

Power 52

3088/I Getting Started Guide B • Specifications

Ethernet 100M

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once

every second.

Ethernet Tx

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once

every second.

Ethernet Rx

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once

every second.

Power

The Model 3088/I power input is 5 VDC from an external desk top power supply, universal input 100–240

VAC, 50–60 Hz, 0.3 A. The universal input power supply has a male IEC-320 power entry connector. This

power supply connects to the Model 3088/I by means of a barrel jack (center pin is +5V) on the rear panel.

Many international power cords are available for the universal power supply (Please refer to Appendix C on

page 54 for country-speciﬁc power cords.

The Model 3088/I powers up as soon as it is plugged into an AC outlet—there is no power switch.

48 VDC power supply

• Input

- Rated voltage: 36–60 VDC

- Rated current: 0.25 A DC

• Output

- Rated voltage: 5 VDC ± 5%, 5W

- Rated current: 1 A DC

- 6-inch cable terminated with 2.5 mm barrel plug, center positive

• Isolation: 500 VDC

Ensure that the power cable used with the external power adapter meets all

applicable standards for the country in which it is to be installed, and that it is

connected to a wall outlet which has earth ground.

The external DC adaptor shall be a listed limited power source

that incorporates a disconnect device and shall be positioned

within easy reach of the operator. The interconnecting cables

shall be rated for the proper voltage, current, anticipated tem-

perature, ﬂammability, and mechanical serviceability

WARNING

CAUTION

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 60 61

No comments

Patton electronic Model 3088/I User Manual Page 52