Patton electronic Model 3088/I User Manual Page 1

Model 3088/I RocketLink-G G.SHDSL NTU Getting Started Guide Sales Office: +1 (301) 975-1000 Technical Support: +1 (301) 975-1007 E-mail: support@pa

10 About this guide This guide describes installing and operating the Patton Electronics Model 3088/I G.SHDSL RocketLink-G™ NTU. Audience This guide

11 3088/I Getting Started Guide Precautions Notes, cautions, and warnings, which have the following meanings, are used throughout this guide to help

12 3088/I Getting Started Guide Safety when working with electricityGeneral observations • Clean the case with a soft slightly moist anti-static clo

13 3088/I Getting Started Guide Typographical conventions used in this document This section describes the typographical conventions and terms used

14 Chapter 1 General information Chapter contents RocketLink-G 3088/I overview ...

RocketLink-G 3088/I overview 15 3088/I Getting Started Guide 1 • General information RocketLink-G 3088/I overview The Patton Electronics Model 3088/

16 Chapter 2 Initial configuration Chapter contents Introduction...

Introduction 17 3088/I Getting Started Guide 2 • Initial configuration Introduction The Model 3088/I (see figure 2) has two configuration modes: RS-23

Configure the IP address 18 3088/I Getting Started Guide 2 • Initial configuration Figure 3. DC Power Supply Power-up indicationThe Power and 100M E

Configure the IP address 193088/I Getting Started Guide 2 • Initial configuration1. Start a HyperTerminal session on the PC using the settings:9600 b

Patton Electronics Company, Inc. 7622 Rickenbacker DriveGaithersburg, MD 20879 USATel: +1 (301) 975-1000Fax: +1 (301) 869-9293Support: +1 (301) 975-1

Configure the IP address 203088/I Getting Started Guide 2 • Initial configurationFigure 5. Connecting the RocketLink-G to the local IP network (Model

Configure the IP address 213088/I Getting Started Guide 2 • Initial configurationNote If two RocketLink-G NTUs are connected back-to-back, one must b

22Chapter 3 G.SHDSL config and statusChapter contentsDSL configuration...

DSL configuration 233088/I Getting Started Guide 3 • G.SHDSL config and statusDSL configurationBy going to the Configuration hyperlink in the Configurat

DSL Error Monitor Configuration 243088/I Getting Started Guide 3 • G.SHDSL config and statusDSL Error Monitor ConfigurationThe DSL Error Monitor provi

G.SHDSL Status 253088/I Getting Started Guide 3 • G.SHDSL config and statusG.SHDSL StatusSelecting the Status hyperlink on the Configuration Menu prov

G.SHDSL Status 263088/I Getting Started Guide 3 • G.SHDSL config and statusDSL Line Error CountersFive counters display how many Loss of Sync’s have

G.SHDSL Status 273088/I Getting Started Guide 3 • G.SHDSL config and statusClearing Error CountersThe error counters may be cleared in the Configurati

28Chapter 4 Ethernet & WAN PPP config and statusChapter contentsIP configuration ...

IP configuration 293088/I Getting Started Guide 4 • Ethernet & WAN PPP config and statusIP configurationThe most commonly used technique for chang

3 Summary Table of Contents 1 General information...

Ethernet port configuration 303088/I Getting Started Guide 4 • Ethernet & WAN PPP config and statusFigure 16. Ethernet performance statisticsEthe

Ethernet port configuration 313088/I Getting Started Guide 4 • Ethernet & WAN PPP config and statusFigure 18. Configurable Ethernet parameters

32Chapter 5 Installation & operationChapter contentsInstallation ...

Installation 333088/I Getting Started Guide 5 • Installation & operationInstallationOnce the Model 3088/I is properly configured, it is ready to c

LED status indicators 343088/I Getting Started Guide 5 • Installation & operationThe Model 3088/I powers up as soon as it is plugged into an AC o

LED status indicators 353088/I Getting Started Guide 5 • Installation & operationEthernet LEDsThere are four Ethernet LEDs: Link, 100M, Tx, and R

36Chapter 6 System ManagementChapter contentsRocketLink-G Plug ‘n’ Play...

RocketLink-G Plug ‘n’ Play 373088/I Getting Started Guide 6 • System ManagementRocketLink-G Plug ‘n’ PlayThe RocketLink-G Plug ‘n’ Play feature allow

Saving the configuration 383088/I Getting Started Guide 6 • System ManagementSaving the configurationTo save all configuration changes into non-volatil

Backing up and restoring saved configurations 393088/I Getting Started Guide 6 • System ManagementBacking up and restoring saved configurationsAt time

4 Table of Contents Summary Table of Contents ...

Authentication 403088/I Getting Started Guide 6 • System ManagementSystem Software UpgradeOver the course of time, new software is released. Also fou

41Chapter 7 Diagnostic toolsChapter contentsLED status monitor & definition ...

LED status monitor & definition 423088/I Getting Started Guide 7 • Diagnostic toolsLED status monitor & definitionSee LED status indicators in

43Chapter 8 Contacting Patton for assistanceChapter contentsIntroduction...

Introduction 443088/I Getting Started Guide 8 • Contacting Patton for assistanceIntroductionThis chapter contains the following information:• “Contac

Warranty Service and Returned Merchandise Authorizations (RMAs) 453088/I Getting Started Guide 8 • Contacting Patton for assistanceOut-of-warranty se

46Appendix A Compliance informationChapter contentsCompliance ...

Compliance 473088/I Getting Started Guide A • Compliance informationCompliance EMC • FCC Part 15, Class A• EN55022, Class A• EN55024Safety• UL 60950-

Industry Canada Notice 483088/I Getting Started Guide A • Compliance informationable protection from such interference in a commercial installation.

49Appendix B SpecificationsChapter contentsGeneral characteristics ...

5 3088/I Getting Started Guide Table of Contents Ethernet port configuration...

General characteristics 503088/I Getting Started Guide B • SpecificationsGeneral characteristics• Compact low-cost Plug ‘n’ Play NTU• 10/100 Ethernet

Management 513088/I Getting Started Guide B • SpecificationsManagement• Web-based configuration via embedded web server• CLI menu for configuration, ma

Power 523088/I Getting Started Guide B • SpecificationsEthernet 100M The DSL LED glows solid while a DSL link is established. While the DSL link is t

Line Interface 533088/I Getting Started Guide B • SpecificationsG.SHDSL Physical connection & Transmission LineRJ-11, Two-wire (single twisted pa

54Appendix C Factory replacement parts and accessoriesChapter contentsFactory replacement parts and accessories ...

Factory replacement parts and accessories 553088/I Getting Started Guide C • Factory replacement parts and accessoriesFactory replacement parts and a

56Appendix D RJ-11 non-shielded DSL portChapter contentsRJ-11 non-shielded DSL port...

RJ-11 non-shielded DSL port 573088/I Getting Started Guide D • RJ-11 non-shielded DSL portRJ-11 non-shielded DSL portSingle twisted-pair (TP) for ful

58Appendix E RJ-45 shielded 10/100 Ethernet portChapter contentsRJ-45 shielded 10/100 Ethernet port...

RJ-45 shielded 10/100 Ethernet port 593088/I Getting Started Guide E • RJ-45 shielded 10/100 Ethernet portRJ-45 shielded 10/100 Ethernet portNote The

6 3088/I Getting Started Guide Table of Contents RMA numbers ...

60Appendix F RS-232 console interface pin assignmentsChapter contentsRS-232 console interface pin assignments...

RS-232 console interface pin assignments 613088/I Getting Started Guide F • RS-232 console interface pin assignmentsRS-232 console interface pin assi

7 3088/I Getting Started Guide Table of Contents RJ-45 shielded 10/100 Ethernet port...

8 List of Figures 1 RocketLink-G 3088/I . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

9 List of Tables 1 General conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .