Patton electronic Model 3088/I User Manual download pdf (Page 29)

IP configuration 29

3088/I Getting Started Guide 4 • Ethernet & WAN PPP config and status

IP conﬁguration

The most commonly used technique for changing the IP address and subnet mask is in the initial conﬁgura-

tion via the console port. However you can also change the IP address in the web GUI pages. In the Conﬁgu-

ration web pages is located the section for changing these two parameters. Enter the IP address and subnet

mask to be used and click on the Update button.

After this change, you must change the IP address in your browser to login and view the web pages again. Be

sure to save the changes into non-volatile memory. (See “Saving the conﬁguration” on page 38.)

Figure 14. Conﬁguration of the IP address and subnet mask

PPP conﬁguration

Also found in the Conﬁguration web pages is the parameter for enabling or disabling the Bridged PPP connec-

tion. Simply select true for enabling the PPP link and click on the Conﬁgure button.

Figure 15. Enabling Bridged PPP over the DSL link

Ethernet port conﬁguration

The Ethernet port rarely needs to be reconﬁgured. However a wealth of Ethernet statistics are available when

analyzing network performance.

Ethernet Basic Port Attributes

Click on the Ethernet hyperlink to see the basic Ethernet statistical parameters. Important statistics include the

link speed, full- or half-duplex operation, the MAC address, collisions and errors. This is primarily a

diagnostic tool.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 60 61

No comments

Patton electronic Model 3088/I User Manual Page 29