Patton electronic 4020 Series User Manual download pdf (Page 75)

Localization 75

SmartLink 4020 Getting Started Guide 7 • System

tone after entering the calling preﬁx key. Before using, call forward busy must be enabled using the activate

sequence deﬁned in the supplementary service table.

Example:

*743019751000 and on-hook the phone. All calls received will forward to 3019751000 when the phone

is busy.

Hotline

Conﬁgures the number to call when the telephone goes off hook. To conﬁgure the hotline number enter the

calling preﬁx key (*75 is the factory default), the number to dial and then on hook the phone. You will hear a

second dial tone after entering the calling preﬁx key. Before using hotline calling it must be enabled using the

activate sequence deﬁned in the supplementary service table.

Example:

*753019751000 and on-hook the phone. When the handset is lifted, 3019751000 will immediately be called.

Control Timer Values

Figure 47. Control Timer Values section of Localization window

Hook Flash Timer

Maximum on-hook time before off-hook to qualify as hookﬂash. More than this value and the on-hook event

is treated as on-hook (hanging up the call).

Minimum on-hook time before off-hook to qualify as hookﬂash. At less than this value, the on-hook event

is ignored.

SIP Session Timer value

The amount of time the SmartLink 4020 will wait during an active call to send repeated re-invites on active

calls to allow the SIP server to determine the status of a call.

Conditional Call Forwarding Timer

Speciﬁed a time period as a call forward condition. After the number of seconds speciﬁed, the conditional call

forwarding process will be performed.

Warm Line Delay

Specify a time period as a delay time for warm line dialing. If warm line is enabled, then the SmartLink 4020

will wait this amount of time after the handset is off-hook before dialing the warm line phone number.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 97 98

No comments

Patton electronic 4020 Series User Manual Page 75