Patton electronic 3088A User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Model 3088A Series Quick Start Guide 5
Connect the serial cable to the OnSite serial port as follows:
1. Attach the male connector of the serial cable to the female serial connector on the OnSite.
2. Attach the other end of the cable to the serial connector on the local serial CPE.
Note You can connect the V.35 interface to an M/34 connector using Patton’s Model 2-34F25M
interface adapter.
Note You can configure the E1 interface to either recover the network clock from the E1 line or supply the
network clock for the E1 line.
5.0 Additional information
For detailed information about installing, configuring, operating, and troubleshooting, refer to the Model 3088A
Series Getting Started Guide at www.patton.com/manuals/3088A.pdf.
A.0 Compliance Information
A.1 Compliance
EMC:
FCC Part 15, Class A
EN55022, Class A
EN55024
Safety:
UL 60950-1/CSA C22.2 N0. 60950-1
IEC/EN60950-1
AS/NZS 60950-1
1.2 Radio and TV Interference (FCC Part 15)
This equipment generates and uses radio frequency energy, and if not installed and used properly—that is, in
strict accordance with the manufacturer's instructions—may cause interference to radio and television recep-
tion. This equipment has been tested and found to comply with the limits for a Class A computing device in accor-
dance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable
protection from such interference in a commercial installation. However, there is no guarantee that interference
will not occur in a particular installation. If the equipment causes interference to radio or television reception,
which can be determined by disconnecting the cables, try to correct the interference by one or more of the fol-
lowing measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna,
and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and
receiver are on different branches).
Page view 4
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments