Patton-electronic 1092ARC User Manual Page 1

USERMANUALMODEL 1092ARCHigh Speed, 2-Wire/4-Wire,Synchronous andAsynchronous Rack MountModem Card SALES OFFICE(301)975-1000TECHNICAL SUPPORT(301)975-1

7. DTE Controlled Remote Digital LoopSelect Option 7 in the SOFTWARE CONFIGURATIONMenu toenable DTE control of the Remote Digital Loop Menu (See below

To run or terminate a particular test, key in the option to get to thatscreen menu. Test Mode options 2,3,7,8 and 9 require the 1092ARC to be in Dat

3.3.1 Model1001RCM12545 Rear Card Strap SettingsFigure 6 shows strap locations for the Model 1001RCM12545(DB-25/RJ-45S) rear cards. These straps det

The table below provides an overview of interface strap functionsfor the rear interface cards. Following the table overview are detaileddescriptions

4.0 INSTALLATIONThis section describes the functions of the Model 1001R14 rackchassis, tells how to install front and rear Model 1092ARC Series cards

4.3.2 Connect to a “DCE” DeviceSince the Model 1092ARC’s serial port is always wired as a DCE,you must use a null modemcable when connecting to anot

5.0 OPERATIONOnce the Model 1092ARC is properly configured and installed, itshould operate transparently. This sections describes functions of theLE

To perform an LLB test, follow these steps:1. Activate LLB. This may be done in one of three ways: - Move the front panel toggle switch to the righ

APPENDIX APATTON ELECTRONICS MODEL 1095RCFACTORY REPLACEMENT PARTSAND ACCESSORIESPatton Model # Description1001RPEM-RAC...120/240V Rear

APPENDIX B (Continued)PATTON MODEL 1092ARC TERMINAL INTERFACE PIN ASSIGNMENTDB-25F Connector-DCE(RS-232 Interface)Pin #Signal1...

1.0 WARRANTY INFORMATION Patton Electronicswarrants all Model 1092ARC components tobe free from defects, and will—at our option—repair or replace the

38APPENDIX DLINE INTERFACE PIN ASSIGNMENT(RJ45 Connector)Pin NumberSignal1...N/C (No Connection)2...

2.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected and tested and iswar

3.0 CONFIGURATIONThis section describes the hardware and software configurationswitches and jumpers, and provides detailed instructions for all possi

3.1.2 Configuration Switch Set “S1”The configuration switches on S1 allow you to specify the datarate, async/sync data format, transmit clock source

Switch S1-8: Response to Remote LoopRequestUse Switch S1-8 to allow the Model 1092ARC to enter the RemoteDigital Loopback diagnostic test when reques

Switch S5-2: 2-Wire/4-WireUse Switch S5-2 to configure 2-Wire or 4-Wire operation.S5-2Setting DescriptionOff 2-Wire 2-Wire OperationOn 4-Wire 4-Wire

MAIN MENU Option 1: Display Active ConfigurationSelect Option 1 to display the most recent configuration of the localModel 1092ARC (See below). The

2. Data FormatSelect Option 2 in the SOFTWARE CONFIGURATIONMenu toselect the sync data format (See below). 3. Clock ModeSelect Option 3 in the SOFTWA