Patton-electronic 3088A User Manual

OnSite Model 3088A SeriesG.SHDSL.bis CPE with fixed serial interfaceUser ManualSales Office: +1 (301) 975-1000Technical Support: +1 (301) 975-1007E-ma

10About this guideThis guide describes installing and operating the Patton Electronics Model 3088A G.SHDSL OnSite™ CPE.AudienceThis guide is intended

11Model 3088A Series User Manual PrecautionsNotes, cautions, and warnings, which have the following meanings, are used throughout this guide to help y

12Model 3088A Series User Manual Safety when working with electricity•Do not open the device when the power cord is connected. For systems without a p

13Model 3088A Series User Manual General observations• Clean the case with a soft slightly moist anti-static cloth• Place the unit on a flat surface a

14Chapter 1 General informationChapter contentsOnSite 3088A overview...

OnSite 3088A overview 15Model 3088A Series User Manual 1 • General informationOnSite 3088A overviewThe Patton Electronics Model 3088A G.SHDSL OnSite

Power input connector 16Model 3088A Series User Manual 1 • General information• 10/100 Ethernet port for management and configuration• Built-in testi

Power input connector 17Model 3088A Series User Manual 1 • General informationExternal 48 VDC power supplyRefer to section “Power and power supply sp

18Chapter 2 ConfigurationChapter contentsIntroduction...

Introduction 19Model 3088A Series User Manual 2 • ConfigurationIntroductionYou can configure the OnSite (see figure 3) in one of two ways:• Software

Patton Electronics Company, Inc.7622 Rickenbacker DriveGaithersburg, MD 20879 USATel: +1 (301) 975-1000Fax: +1 (301) 869-9293Support: +1 (301) 975-100

Introduction 20Model 3088A Series User Manual 2 • ConfigurationTable 2 lists the Model 3088A’s configurable parameters.Table 2. OnSite configurable p

Introduction 21Model 3088A Series User Manual 2 • ConfigurationConfiguring the DIP switchesThe Model 3088A is equipped with three sets of DIP switche

Introduction 22Model 3088A Series User Manual 2 • ConfigurationThe three sets of DIP switches are externally accessible from the underside of the Mod

Introduction 23Model 3088A Series User Manual 2 • ConfigurationDIP switch settingsThe following tables provide an overview of the OnSite DIP switch f

Introduction 24Model 3088A Series User Manual 2 • ConfigurationS4-2 through S4-8: Data Rate Switches S4-2 through S4-8 define both the DSL line rate

Introduction 25Model 3088A Series User Manual 2 • ConfigurationOFF ON OFF OFF OFF OFF ON 2240OFF ON OFF OFF OFF ON OFF 2304OFF ON OFF OFF OFF ON ON 2

Introduction 26Model 3088A Series User Manual 2 • ConfigurationDCE/DTE operationNoteThis section applies to the following 3088A models:- 3088A/A - RS

Introduction 27Model 3088A Series User Manual 2 • ConfigurationEthernet Management PortThe 3088A offers a 10/100 Ethernet port for configuration and

Introduction 28Model 3088A Series User Manual 2 • Configuration• Annex: Either G.991.2 Annex A or Annex B.The following status information is availab

Introduction 29Model 3088A Series User Manual 2 • Configuration- Bursty Errored Seconds- Degraded MinutesHelp CommandsThe following commands are prov

3Summary Table of Contents1 General information...

Introduction 30Model 3088A Series User Manual 2 • ConfigurationDSL Configuration CommandsThe following commands are used to configure the DSL:• dsl s

Introduction 31Model 3088A Series User Manual 2 • ConfigurationRemote ConsoleProvided that there is a DSL link to a second 3088A, a user may login to

Introduction 32Model 3088A Series User Manual 2 • Configuration password ... Set the login password. circuitid ... Change the circuit ID cl

Introduction 33Model 3088A Series User Manual 2 • ConfigurationOnSite Plug ‘n’ Play The OnSite Plug ‘n’ Play feature allows ISPs, carriers and PTTs t

34Chapter 3 OnSite installationChapter contentsInstallation ...

Installation 35Model 3088A Series User Manual 3 • OnSite installationInstallationOnce the Model 3088A is properly configured, it is ready to connect

Installation 36Model 3088A Series User Manual 3 • OnSite installationConnecting the Model 3088A serial interfaceThis section describes how to connect

Installation 37Model 3088A Series User Manual 3 • OnSite installationConnecting the Model 3088A/K serial interfaceThe Model 3088A/K provides an E1 (G

Installation 38Model 3088A Series User Manual 3 • OnSite installationConnecting dual coaxial cable (75 ohm) to E1 networkThe Model 3088A/K is also eq

Installation 39Model 3088A Series User Manual 3 • OnSite installationConnecting powerExternal AC universal power supply1. Connect the power cord from

4Table of ContentsSummary Table of Contents ...

Installation 40Model 3088A Series User Manual 3 • OnSite installationDC Power The 36-60 VDC DC to DC adapter is supplied with the DC version of the M

41Chapter 4 OperationChapter contentsIntroduction...

Introduction 42Model 3088A Series User Manual 4 • OperationIntroductionOnce the Model 3088A is properly configured and installed, it should operate t

Introduction 43Model 3088A Series User Manual 4 • OperationTerminal (Green) The Terminal LED glows solid under the following circumstances:• 3088A/CA

Introduction 44Model 3088A Series User Manual 4 • OperationNoteLocal loopback causes bit errors on the remote end if the link is up..Figure 14. Local

45Chapter 5 Remote console operationChapter contentsIntroduction...

Introduction 46Model 3088A Series User Manual 5 • Remote console operationIntroductionThe PC user (near-end) may configure and verify status of the r

Introduction 47Model 3088A Series User Manual 5 • Remote console operationNoteThe local or remote 3088A may be CO or CPE, as long as there is one of

Introduction 48Model 3088A Series User Manual 5 • Remote console operationThe response upon logging out of the remote console session with the comman

49Chapter 6 Software UpgradeChapter contentsIntroduction...

5Model 3088A Series User Manual Table of Contents Example Command Line Interface Session ...

Introduction 50Model 3088A Series User Manual 6 • Software UpgradeIntroductionThe software upgrade feature is available through BOOTP/TFTP. The softw

51Chapter 7 Reset configuration to factory defaultsChapter contentsIntroduction...

Introduction 52Model 3088A Series User Manual 7 • Reset configuration to factory defaultsIntroductionThe configuration can be reset to factory defaul

53Chapter 8 Contacting Patton for assistanceChapter contentsIntroduction...

Introduction 54Model 3088A Series User Manual 8 • Contacting Patton for assistanceIntroductionThis chapter contains the following information:• “Cont

Warranty Service and Returned Merchandise Authorizations (RMAs) 55Model 3088A Series User Manual 8 • Contacting Patton for assistanceOut-of-warranty

56Appendix A Compliance informationChapter contentsCompliance ...

Compliance 57Model 3088A Series User Manual A • Compliance informationCompliance EMC • FCC Part 15, Class A• EN55022, Class A• EN55024Safety• UL 6095

58Appendix B SpecificationsChapter contentsClocking modes...

Clocking modes 59Model 3088A Series User Manual B • SpecificationsClocking modesInternal, external, or receive recoveredDTE rateAll 64k steps from 64

6Model 3088A Series User Manual Table of Contents Patton support headquarters in the USA ...

Configuration 60Model 3088A Series User Manual B • SpecificationsTerminal (Green)The Terminal LED glows solid under the following circumstances:• 308

Transmission line 61Model 3088A Series User Manual B • SpecificationsFigure 19. Power connection barrel receptacle 5 VDC diagramExternal AC universal

Line rates (DSL line) 62Model 3088A Series User Manual B • SpecificationsLine rates (DSL line)All nx64 rates from 192kbps up to 5.696 MbpsLine interf

63Appendix C Factory default valuesChapter contentsFactory default values for software-configurable parameters...

Factory default values for software-configurable parameters 64Model 3088A Series User Manual C • Factory default valuesFactory default values for sof

Factory default values for software-configurable parameters 65Model 3088A Series User Manual C • Factory default valuesTable 9. 3088A/KParameter Defa

66Appendix D Factory replacement parts and accessoriesChapter contentsFactory replacement parts and accessories...

Factory replacement parts and accessories 67Model 3088A Series User Manual D • Factory replacement parts and accessoriesFactory replacement parts and

68Appendix E Interface pinoutsChapter contentsLine port ...

Line port 69Model 3088A Series User Manual E • Interface pinoutsLine portRJ-45 connectorRS-232 interfaceDB-25 female connector (DTE/DCE orientation)P

7Model 3088A Series User Manual Table of Contents Factory default values for software-configurable parameters...

V.35 interface 70Model 3088A Series User Manual E • Interface pinoutsV. 3 5 i n t e r f a c eDB-25 female connector (DTE/DCE orientation)E1 interfac

X.21 interface 71Model 3088A Series User Manual E • Interface pinoutsX.21 interfaceD-sub-15 female connector (DTE/DCE orientation)Ethernet Console po

8List of Figures1 OnSite 3088A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

9List of Tables1 General conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .