Patton electronic CopperLINK 2158B User Manual Page 1

USER MANUAL MODEL 2158B CopperLINK™ Ethernet Extender SALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007 Part# 07M2158B-UMRev. ARevised 4/8/1

10 Figure 2. Model 2158B standalone rear panel 3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE The Model 2158B supports communication between two pe

11 1. To function properly, the two Model 2158Bs must be connected together using twisted-pair, unconditioned, dry, metal wire, between 19 (0.9mm)

12 Figure 4. Model 2158B 10/100Base-T RJ-45 Connector Pinout. 3.3 CONNECTING POWER The Model 2158B does not have a power switch, so it powers up as

13 Figure 5. Removing protective cover Figure 6 on page 13 shows the orientation of the DIP switches in the On and Off positions. Figure 6. DIP swi

14 4.2 CONFIGURING DIP SWITCH S1 DIP switch S1 is where you configure the CopperLINK line. The following table describes the configuration for the 215

15 5.2 FRONT PANEL LED STATUS MONITORS The Model 2158B features six front panel LEDs that monitor power, the Ethernet signals, the CopperLINK connec

16 APPENDIX A SPECIFICATIONS A.1 LAN CONNECTION • Two shielded RJ-45, 10/100Base-T, IEEE 802.3 Ethernet• CopperLINK Connection: Shielded RJ-45 A.

17 APPENDIX B MODEL 2158B SERIES FACTORY REPLACEMENT PARTS AND ACCESSORIES *Only required with optional UI power supply (08055DCUI) Patton Model #Des

18 APPENDIX C MODEL 2158B SERIES INTERFACE PIN ASSIGNMENT C.1 10/100BASE-T INTERFACE RJ-45 • Pin 1: TX+• Pin 2: TX-• Pin 3: RX+• Pin 6: RX-• Pins 4,

19 APPENDIX D DISTANCE CHART, BASED ON 24 AWG (0.5 MM) Note The actual distance and link performance may vary depending on the environment and type/g

2 CONTENTS1.0 Warranty Information ... 4 1.1 Regulatory Information ...

20Copyright © 2010.Patton Electronics CompanyAll Rights Reserved.

3 DDistance Chart, Based on 24 AWG (0.5 MM)... 19

4 1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 2158B components to be free from defects, and will—at our option—repair or replace

5 of Part 15 of FCC rules, which are designed to provide reasonable pro-tection from such interference in a commercial installation. However, there i

6 1.6 SAFETY WHEN WORKING WITH ELECTRICITY • This device contains no user serviceable parts. This device can only be repaired by qualified service p

7 In accordance with the requirements of council direc-tive 2002/96/EC on Waste of Electrical and Electronic Equipment (WEEE), ensure that at end-of-

8 2.0 GENERAL INFORMATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and

9 Figure 1. Typical application The pair of 2158B models work together to create a transparent extension between two peered Ethernet LANs. Figure 1