Patton-electronic 1089/I User Manual

USERMANUALMODEL 1089/I10BaseT HDSL RocketPart# 07M1089/I-ADoc# 032071UARevised 12/7/99SALES OFFICE(301)975-1000TECHNICAL SUPPORT(301)975-1007http://ww

5.3.2 Loops and PatternsThe following section describes the Remote Loopback/BER testmodes. Remote Digital When Remote Loop/511 or Remote Loop/511/E

AAPPPPEENNDDIIXX AAPPAATTTTOONN EELLEECCTTRROONNIICCSS MMOODDEELL 11008899SSPPEECCIIFFIICCAATTIIOONNSSClocking Modes: Internal or Receive RecoveredD

AAPPPPEENNDDIIXX DDPPAATTTTOONN EELLEECCTTRROONNIICCSS MMOODDEELL 11008899TTRRAANNSSMMIISSSSIIOONN DDIISSTTAANNCCEESSCopyright ©1999Patton Electronics

TTAABBLLEE OOFF CCOONNTTEENNTTSSSection Page1.0 Warranty Information...21.1 Radio and TV Int

1.3 SERVICEAll warranty and non-warranty repairs must be returned freightprepaid and insured to Patton Electronics. All returns must have aReturn Ma

33..00 CCOONNFFIIGGUURRAATTIIOONNThe Model 1089 has two sets of eight DIP switches, which allowconfiguration for a wide variety of applications. Thi

73.1.2 Configuration Switch Set “S3” Use the DIP Switches in Switch S3 to set the DTE Rate (for LANBandwidth Allocation), the transmit data sampling p

944..00 IINNSSTTAALLLLAATTIIOONNWhen the Model 1089 has been properly configured, it may beconnected to the DSL twisted pair interface, the 10BaseT E

114.4 POWER CONNECTIONUniversal AC Power (100-240VAC)The Model 1089 uses a 5VDC, 2A universal input 100-240VAC,power supply (center pin is +5V). The

7 pulses = WAN receive frame(s) aborted8 pulses = Detected WAN receive frame(s) with CRC9 pulses = Detected LAN receive frame(s) too large10 pul

(because it originates after the framer) and isintended to be evaluated only by anotherProcessor. If the units are transmitting data andthe pattern ge