USERMANUALModel 1000RP SeriesAC and DC Rack MountPower SuppliesSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007Part# 07M1000RP-BDoc# 078011UB
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1000RP Seriescomponents to be free from defects, and will—at our option—repair orrepla
Front (Power Supply) Card Installation1. Make sure the power switch is in the OFF position.2. Slide the power supply card into the front of the chassi
4.0 OPERATIONOnce the Model 1000RP Series power supply module is properlyinstalled, you are ready to operate the unit. Figure 3 (below) shows theloc
5.0 SERVICE PROCEDURESThis section describes the procedures for Power Line VoltageSettings and Fuse Replacement for Patton Models 1000RPSM-2,1000RPEM
8. Replace the spare fuse with one of the appropriate size and ratingand close the drawer.9. Re-install the power cord.(Step #6- 9 for Model 1000RPEM-
(APPENDIX A - Continued)1000RPSM-48A/24A/12A (DC Front Card):Power Supply: 48V DC (-48A version); 24V DC (-24A version); 12VDC (-12A version)Inp
Comments to this Manuals